The Airbag Man Air Helper Kit for Mazda Bravo works alongside your factory rear leaf spring suspension to correct sag under load, using two air bags mounted between the axle and chassis rail. Air pressure is adjustable from empty (soft, unloaded ride) up to a firm setting for towing a caravan or carrying a loaded canopy — you dial in only the support you need, when you need it. The kit ships complete with nylon air lines, mounting hardware and fitting instructions, and it doesn't alter unladen ride height or geometry. Supplied in Australia with manufacturer warranty and fitment support from our suspension team.
Browse all compatible suspension parts for your Air Helper Kit Mazda Bravo using our parts finder.
Note: Air compressor sold separately — manual inflation valve included for use with portable compressor or service station air.
| Make | Model | Series | Years | Engine |
|---|---|---|---|---|
| Mazda | Bravo B2500 | Leaf spring rear, 2WD/4WD | 1999-2006 | 2.5L turbo diesel |
| Mazda | Bravo B2600 | Leaf spring rear, 2WD/4WD | 1999-2006 | 2.6L petrol |
Not sure if this fits your vehicle? Contact our suspension experts or check our FAQ page.
This helper kit is designed to work alongside your existing rear leaf springs rather than replace them, so spring rate selection comes down to what accessories are permanently fitted to the rear of the vehicle. Constant loads such as a steel canopy, dual battery tray, water tank, toolboxes or a bullbar-equivalent rear counterweight all reduce available sag margin before you even hook up a trailer. If you're carrying a heavy constant payload or towing regularly, talk to our team about whether a heavier duty leaf spring pairs better with this kit than relying on air pressure alone.
Fitment involves mounting the air bags between the axle and chassis rail using the supplied brackets, then routing the nylon air lines to an accessible inflation point — most owners have this done by an experienced installer or a competent DIY fitter with basic hand tools. A wheel alignment check is recommended after fitting, particularly if the kit is run at higher pressure for extended towing. Allow the mounting hardware to settle over the first 500km and recheck bolt torque. For vehicles carrying heavy constant loads, pairing this kit with upgraded control arm or leaf spring components can further improve load-carrying stability.
Airbag Man has built its air suspension range specifically for Australian conditions, with kits developed for the load and towing demands common on local roads and tracks. Kits are backed by manufacturer warranty and are trusted by tradespeople and caravan tourers who need adjustable support rather than a fixed spring rate. View the full Airbag Man range to compare helper kits across other 4WD platforms.
This kit suits Mazda Bravo owners who tow a caravan or trailer occasionally and need extra rear support only when hooked up, plus tradespeople running a canopy or toolboxes who want to correct sag without a permanent spring change. If you're after adjustable airbag suspension that you can dial up or down depending on the load, this is the more flexible option compared to a fixed heavy-duty leaf spring.
In stock in Australia with fast dispatch and fitment support from our suspension team — browse our full lift kit range if you're also considering a permanent suspension upgrade.
This Airbag Man kit is built for Mazda Bravo models with rear leaf spring suspension, covering the B2500 and B2600 variants sold in Australia from 1999 to 2006. It mounts between the rear axle and chassis rail using the supplied brackets, so it works with the factory leaf spring layout rather than replacing it. If you're unsure which series or cab configuration you have, our team can confirm fitment before you order.
This is an air helper kit, not a lift kit, so it does not raise unladen ride height. When deflated the vehicle sits on its standard leaf springs; when inflated the air bags provide adjustable support that levels the rear end under load, such as when towing or carrying a heavy canopy. If you want a permanent height increase as well as load support, ask us about pairing this kit with raised rear leaf springs.
The kit includes two air bags, mounting brackets for the axle and chassis rail, a nylon air line kit, air fittings and inflation valve, plus all mounting hardware and fitting instructions specific to the Mazda Bravo rear end. Factory leaf springs stay in place and are not replaced by this kit. A full itemised list is shown in the Kit Includes section above.
Yes, this is one of its main uses. Inflating the air bags to a firmer setting counteracts rear sag from caravan ball weight or a loaded trailer, helping keep the vehicle level and the headlights aimed correctly. Once you unhook the trailer you simply deflate the bags back down for a softer unladen ride.
Not for this kit specifically, since it works with the existing rear leaf spring geometry rather than changing ride height. If you're also fitting a lift or upgraded leaf springs at the same time, it's worth reviewing control arm options for correct alignment angles. Our team can advise based on your full setup.
A wheel alignment check is recommended after installation, particularly if you regularly run the bags at higher pressure for towing. Because this kit doesn't change static ride height, the alignment impact is generally minor compared to a full lift kit, but checking is still good practice. We suggest a check after the first 500km of use.
This kit works alongside your existing leaf springs rather than offering a spring rate choice itself — the air pressure is what you adjust, not a fixed spring rate. If your constant accessory load is heavy, such as a steel canopy or water tank, our team can advise whether a heavier duty leaf spring alongside this kit suits your setup better than air pressure alone.
Since this kit does not raise ride height, it won't create extra clearance for larger tyres on its own. Tyre clearance on a Mazda Bravo depends on the wheel arch, offset and any existing lift, so check with our team before fitting oversized rubber. If more clearance is the goal, ask us about combining this kit with raised leaf springs.
This Airbag Man kit is covered by manufacturer warranty against manufacturing defects. Warranty terms and claim conditions are provided with the kit documentation, and our team can talk you through the specifics for the Mazda Bravo application. Keep your invoice as proof of purchase for any warranty claim.
Yes. Since the air bags can be run at low or no pressure when unloaded, day-to-day ride comfort stays close to standard, with the option to firm things up only when carrying a load or towing. This makes it a practical option for Bravo owners who drive unladen most of the time but need occasional load support.
Help other 4WDSuspension users shop smarter by writing reviews for products you have purchased.
Add your favourites to cart
Log into or create your Afterpay account, with instant approval decision
Your purchase will be split into 4 payments, payable every 2 weeks
All you need to apply is to have a debit or credit card, to be over 18 years of age, and to be a resident of country offering Afterpay
Late fees and additional eligibility criteria apply. The first payment may be due at the time of purchase
For complete terms visit afterpay.com/terms
