The Dobinsons Nitro Gas Front Lift Kit suits the Toyota Hilux N70 (2005-2015) and delivers a 2" to 3" front lift using twin-tube nitrogen gas shocks paired with precision-matched coil springs. Japanese seals and German shock oil manage heat and load without losing damping control on corrugations. This front-only kit lifts nose height to correct stance after bullbar or winch fitment and improves control at highway speed. In stock in Australia now, backed by a manufacturer warranty and fitment support from our team.
Browse all compatible suspension parts for your Front Lift Kit Toyota Hilux N70 using our parts finder.
| Make | Model | Series | Years | Engine |
|---|---|---|---|---|
| Toyota | Hilux | N70 | 2005-2015 | 3.0L D-4D (1KD-FTV), 2.5L D-4D (2KD-FTV), 4.0L V6 petrol (1GR-FE) |
Not sure if this fits your vehicle? Contact our suspension experts or check our FAQ page.
Lift height compliance: Suspension lifts of this size may exceed your state's allowable limit without engineering certification. Check your state's light vehicle modification rules (VSB14/NCOP) before fitting.
Front spring rate should match the weight of accessories fitted ahead of the front axle. A steel bullbar, winch and driving lights add sustained weight that a standard-rate spring will sag under over time. Common front accessories to account for include steel bullbars, winches, driving light bars and long-range fuel tanks mounted forward of the axle — tell our team what you're running and we'll confirm the right spring for your Hilux N70.
This is a bolt-in front strut replacement suited to an experienced DIY fitter with strut compressor tools, or a four-wheel-drive workshop for a straightforward fit. Wheel alignment is mandatory after installation to reset camber and caster at the new ride height. Allow a 500km bedding-in period for the springs to settle before fine-tuning alignment again. If you're running a heavier front-end setup, pair this kit with upgraded control arms to correct CV joint angles and extend arm travel at full lift.
Dobinsons has built 4WD suspension in Australia for decades and tunes its Nitro Gas range around local roads, fuel loads and towing conditions rather than generic overseas settings. Every kit is backed by a manufacturer warranty and the brand is used by tourers, tradespeople and remote-area travellers across the country. Browse the full Dobinsons range to see matching rear leaf springs, shocks and steering dampers for your Hilux N70.
This kit suits Hilux N70 owners who've added a bullbar, winch or driving lights and need the front end lifted back to level, plus tourers wanting extra front travel for corrugated roads and station tracks. Tradespeople carrying tool boxes or canopy weight on the rear should also look at airbag suspension to manage constant rear load alongside this front lift.
This Dobinsons Nitro Gas Front Lift Kit for the Toyota Hilux N70 is in stock now for fast Australia-wide dispatch, backed by manufacturer warranty and fitment support from our team. Browse our full lift kit range to build a complete front and rear suspension package for your Hilux.
New to Hilux suspension? Read our guide to common Hilux suspension problems and how to fix them.
This kit is designed for the Toyota Hilux N70 built 2005 to 2015, covering 3.0L D-4D (1KD-FTV), 2.5L D-4D (2KD-FTV) diesel and 4.0L V6 petrol (1GR-FE) variants. It replaces the factory front strut assembly with a Dobinsons Nitro Gas unit matched to this chassis. If you're unsure of your exact build date or engine, check your compliance plate or contact our team before ordering.
The front struts give a 2" to 3" lift measured at the front of the vehicle, depending on accessory load and spring selection. Rear ride height is unaffected because this is a front-only kit — pair it with a matched Dobinsons rear leaf spring kit for an even stance front to rear. Actual lift on your vehicle can vary slightly with GVM, tyre size and accessories already fitted.
Please note that all assembled struts are dispatched at a height based on our experience and the manufacturer’s specifications for the advertised lift. Coil springs and leaf springs are also manufactured according to the advertised height and constant-load rating. Actual vehicle height may vary depending on the vehicle and the weight of fitted accessories. Further adjustment may therefore be required after installation. The installer may use coil spacers or adjust the struts at their discretion to achieve the desired height. We are not responsible for vehicle-specific height variations or any additional adjustments required after installation.
The kit includes two Dobinsons Nitro Gas front strut assemblies, each combining a twin-tube nitrogen gas shock absorber and a matched 2" to 3" front coil spring as a single pre-assembled unit. Mounting hardware and fitting instructions are included. Rear springs, rear shocks and control arms are not included and are sold separately.
Yes, front spring rates in this kit are selected to carry the added weight of common front-end accessories such as bullbars and winches, which helps maintain front-end geometry when towing. Towing performance also depends on your rear suspension setup and GVM upgrade status. Talk to our team about matching rear leaf springs or airbag suspension if you're towing regularly.
It depends on your lift height and tyre size. At 2" to 3" of front lift, many Hilux N70 owners fit upgraded control arms to correct CV joint angles and restore proper front geometry, especially with larger tyres. Our team can advise whether your specific combination needs a control arm upgrade.
Yes, wheel alignment is mandatory after installing this kit. Ride height changes at the front axle alter camber and caster, and an alignment resets these to the correct specification for tyre wear and steering feel. We recommend a 500km bedding-in period before a final alignment check.
Dobinsons offers different front spring rate options for the Hilux N70 depending on your accessory load, such as a bullbar, winch or driving lights. Contact our team with details of what's fitted to your front end and we'll confirm the correct spring rate for your vehicle.
A 2" to 3" front lift creates additional clearance for larger tyres, though final fitment depends on tyre diameter, rim width and offset. We recommend confirming your intended tyre size with our team so we can advise on any rubbing points at full steering lock or suspension compression.
This kit is backed by a Dobinsons manufacturer warranty covering defects in materials and workmanship. Full warranty terms are confirmed at the time of purchase — contact our team for the specific warranty period applying to this kit.
Yes. The twin-tube nitrogen gas shock design is tuned to keep a comfortable ride on sealed roads while adding the travel and control needed for corrugated tracks and light off-road use. Many Hilux N70 owners run this kit as their daily setup, with the added benefit of correcting stance after fitting a bullbar or winch.
Help other 4WDSuspension users shop smarter by writing reviews for products you have purchased.
Add your favourites to cart
Log into or create your Afterpay account, with instant approval decision
Your purchase will be split into 4 payments, payable every 2 weeks
All you need to apply is to have a debit or credit card, to be over 18 years of age, and to be a resident of country offering Afterpay
Late fees and additional eligibility criteria apply. The first payment may be due at the time of purchase
For complete terms visit afterpay.com/terms
